Complex technical support of concerts and show programs

+7 (495) 970-42-88
МЕНЮ

The line array EAW JFL 118

Features

Produced by: LOUD Technologies Inc., USA

Operating Range (-10 dB, Hz): 30 – 150

Axial Sensitivity (1W @ 1m, dB SPL): Sub: 94

Power Handling / Impedance (Watts @ Ohms): Sub – Single Amp: 800 @ 8

Calculated Maximum Output Peak (dB SPL): Sub (whole space): 129

Calculated Maximum Output Long Term (dB SPL): Sub (whole space): 123

Powering: Single

Dimensions (inches/millimeters): Height: 24.80/631 Width: 19.80/502 Depth: 29.10/740

Weights (pounds/kilograms): 98/44.5

Цена

по запросу

Application for rent

Discount 20% when ordering from site

Description

The JFL118 is a light weight, high-powered, flyable, single 18-inch subwoofer that extends the low frequency response of the companion JFL210 or JFL213 full range line array loudspeakers. JFL118 subwoofers may be ground stacked, flown as part of a JFL210 or JFL213 array or flown separately alongside a JFL210 or JFL213 array. Integral, proprietary rigging will suspend up to six of any combination of JFL118 and JFL210/ JFL213 enclosures with a 10:1 design factor. The optional FB221 fly bar includes multiple suspension points that allow users to easily set an array’s tilt angle. The JFL118 also includes M10 threaded suspension points that allow users to deploy arrays in permanently installed applications by means of cost-effective, forged shoulder eyebolts.
The JFL118 includes a metal cup that allows up to two JFL210 or JFL213 main channel loudspeakers to be pole mounted above up to two stacked JFL118’s. Alternately, JFL210 or JFL213 loudspeakers may be stacked directly atop the JFL118. In this instance, all enclosures lock together using their integral rigging.

JFL118 subwoofers utilize Neutrik® Speakon® STX Series connectors. The STX Series’ all-metal housings are extremely rugged, and feature a built-in gasket providing weather protection to IP54 when used with companion NLT4FX in-line cable connectors. The rear of each JFL118 features three NL4 connectors. Two are used for subwoofer and optional high passed signal input, while the third is used as an output to loop the high-passed signal to JFL210’s, JFL213’s or other loudspeakers.